|
|
@@ -4,10 +4,10 @@
|
|
|
<para>
|
|
|
Before you can actually start doing something with a package, you need
|
|
|
to unpack it first. Often you will find the package files being tar'ed and
|
|
|
-gzip'ed (you can determind this by looking at the extension of the file.
|
|
|
-tar'ed and gzip'ed archives have a .tar.gz or .tgz extension for
|
|
|
-example)). I'm not going to write down every time how to ungzip and how
|
|
|
-to untar an archive. I will tell you how to do that once, in this paragraph.
|
|
|
+gzip'ed. (You can determine this by looking at the extension of the file.
|
|
|
+tar'ed and gzip'ed archives have a .tar.gz or .tgz extension, for
|
|
|
+example.) I'm not going to write down every time how to ungzip and how
|
|
|
+to untar an archive. I will tell you how to do that once, in this section.
|
|
|
There is also the possibility that you have the ability of downloading
|
|
|
a .tar.bz2 file. Such a file is tar'ed and compressed with the bzip2 program.
|
|
|
Bzip2 achieves a better compression than the commonly used gzip does. In
|
|
|
@@ -73,7 +73,7 @@ When you have a file that is tar'ed, you unpack it by running:
|
|
|
When the archive is unpacked a new directory will be created under the
|
|
|
current directory (and this document assumes that you unpack the archives
|
|
|
under the $LFS/usr/src directory). You have to enter that new directory
|
|
|
-before you continue with the installation instructions. So everytime the
|
|
|
+before you continue with the installation instructions. So every time the
|
|
|
book is going to install a program, it's up to you to unpack the source
|
|
|
archive.
|
|
|
</para>
|
|
|
@@ -91,8 +91,8 @@ When you have a file that is gzip'ed, you unpack it by running:
|
|
|
<para>
|
|
|
After you have installed a package you can do two things with it. You can
|
|
|
either delete the directory that contains the sources or you can keep it.
|
|
|
-If you decide to keep it, that's fine by me. But if you need the same package
|
|
|
-again in a later chapter you need to delete the directory first before using
|
|
|
+If you decide to keep it, that's fine with me. But, if you need the same package
|
|
|
+again in a later chapter, you need to delete the directory first before using
|
|
|
it again. If you don't do this, you might end up in trouble because old
|
|
|
settings will be used (settings that apply to your normal Linux system but
|
|
|
which don't always apply to your LFS system). Doing a simple make clean
|
Simon Perreault